LTZ 2.8L-180,000MILES

1989 Chevrolet Corsica

Tiny

dan hogle

June, 2, 2007 AT 6:24 PM

My engine primes & starts, but it only runs for about 1 sec. I changed my fuel pump, fuel filters, fuel regulator. I don't get a code reading from my car when I do a trouble shooting read out. I was told thar it could be my fuel relay switch, but I dont know where it is located @. Someone told me that it could be behind my kick panel on the driver side, but I dont want to take it apart unless I know for sure that it is behind there

FOUND 970 RELATED QUESTIONS

1 Answer

Tiny

e40water12

June, 9, 2007 AT 6:21 PM

Fuel relay switch is located in the engine compartment, On the drivers side, U will see a fuse panel, The relay should be a black box looking thing with 2-3 wires coming out of it. Also have u tested youre coil packs, Are they putting out, Enough ohm's, Also would look into getting map sensor vaccum hose checked could have a crack in the rubber line.

Please login or register to post a reply.

Fuel Pump Replacement Done Right
Fuel Pump Replacement Ford Mustang
Fuel Pump Replacement
Fuel Pump Test Chevy Tahoe