AC cold on passenger side but warm on drivers side

Tiny
CURTISAUTO
  • MEMBER
  • 2007 CHEVROLET UPLANDER
  • 6 CYL
  • AUTOMATIC
  • 90 MILES
This uplander is cold on passenger side but warm on drivers side I took the tem contol off on drivers side and the motor is going full motion and door seems to be moving properly and can move from hot to cold with motor off and still does not get cold 50 degrees on drivers and 40 degrees on passenger
Do you
have the same problem?
Yes
No
Monday, May 16th, 2011 AT 7:51 PM

7 Replies

Tiny
WRENCHER1
  • EXPERT
This is a blend door actuator problem on the drivers side, even though it works the monitoring is off this guide will help us fix it

https://www.2carpros.com/articles/replace-blend-door-motor

Please run down these guides and report back.
Was this
answer
helpful?
Yes
No
Monday, May 16th, 2011 AT 9:15 PM
Tiny
CURTISAUTO
  • MEMBER
Just did the actuator you were right it works perfect now.
Was this
answer
helpful?
Yes
No
Monday, May 16th, 2011 AT 9:34 PM
Tiny
WRENCHER1
  • EXPERT
Nice work, we are here to help, please use 2CarPros anytime.
Was this
answer
helpful?
Yes
No
Monday, May 16th, 2011 AT 9:42 PM
Tiny
PEEWEERASEL
  • MEMBER
  • 2005 CHEVROLET UPLANDER
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 95,000 MILES
My left driver side air blows hot. I have been told that its an actuator. I need to know where its location is and which one i'm looking for, because there is a few when I looked at liberay mannual.
Was this
answer
helpful?
Yes
No
Thursday, July 9th, 2020 AT 7:06 PM (Merged)
Tiny
WRENCHER1
  • EXPERT
Here are the actuator location in the diagrams below. Check out the diagrams (Below). Please let us know what you find. We are interested to see what it is.
Was this
answer
helpful?
Yes
No
-1
Thursday, July 9th, 2020 AT 7:06 PM (Merged)
Tiny
PEEWEERASEL
  • MEMBER
Thanks for the locations I got new actuator motor which did the trick.
Was this
answer
helpful?
Yes
No
Thursday, July 9th, 2020 AT 7:06 PM (Merged)
Tiny
WRENCHER1
  • EXPERT
Good to hear, please use 2CarPros anytime we are here to help.
Was this
answer
helpful?
Yes
No
Thursday, July 9th, 2020 AT 7:06 PM (Merged)

Please login or register to post a reply.

Sponsored links