I put a new radiator in and a crankshaft position sensor, I think it might be the computer system.
Oct 24, 2022 at 8:21 AM
it starts and idles at 1,400 RPMs but will not drive?
2007 DODGE CHARGER
CURTIS5.7
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Hi,
I'm not sure I understand what is happening. It starts but won't drive. Is the engine stalling? What happens when you place it in gear?
Let me know as much as you can. Also, if you haven't already, you should consider scanning the can-bus system. CAN stands for controller area network. Basically, all the different modules are tied together via a few wires. This type of scan will retrieve codes regardless of the module storing them.
Here is a link showing how it's done:
https://www.2carpros.com/articles/can-scan-controller-area-network-easy
Let me know.
Joe
I'm not sure I understand what is happening. It starts but won't drive. Is the engine stalling? What happens when you place it in gear?
Let me know as much as you can. Also, if you haven't already, you should consider scanning the can-bus system. CAN stands for controller area network. Basically, all the different modules are tied together via a few wires. This type of scan will retrieve codes regardless of the module storing them.
Here is a link showing how it's done:
https://www.2carpros.com/articles/can-scan-controller-area-network-easy
Let me know.
Joe
Oct 24, 2022 at 8:11 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.