2006 Nissan Pathfinder How Solve this Problem

Tiny
FIIFI
  • MEMBER
  • 2006 NISSAN PATHFINDER
  • 3.5L
  • 6 CYL
  • 4WD
  • AUTOMATIC
Please,

I have diagnosed a pathfinder engine 3500 with the following codes

1. P1490 - Sec. Air Relief Solenoid Circuit Malfunction
2. P0460 - Fuel Level Sensor Circuit
3. P0550 - Power Steering Pressure Sensor Circuit
4. P0183 - Fuel Temp. Sensor A Circuit High Imp.
5. P0447 - Evap. Emission Control System, Vent. Circuit

What happens is that any time you clear these codes it drives very smoothly but after an hour or more the check engine comes back and the engine doesn"t pull. Fault code comes back again.

This is my first time using your platform and I believe you will help me solve this problem and locate necessary components.

Thank you very much.

Fiifi
Ghana
Thursday, April 24th, 2014 AT 5:27 AM

7 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
We have no listing for p1490 first thing to do though is to check battery for condition including load test. Low voltage can cause this. Two fo the codes arefor fuel pressure in tank so it has to be checked for voltages prior to replacing sensors as the tank has to be dropped to fix those. You might check wiring for being grounded out as well. The other is a evap sensor inevap tank is leaking. See pic.
Was this
answer
helpful?
Yes
No
+1
Thursday, April 24th, 2014 AT 5:52 AM
Tiny
FIIFI
  • MEMBER
  • 5 POSTS
Thanks so much Sir, I will follow your instructions. But please is there any software/DVD Rom for vehicles component locations. Or fault codes which refers to component location. Please advise.

Fiifi
Was this
answer
helpful?
Yes
No
Friday, April 25th, 2014 AT 8:40 AM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
You need a manual for that
Was this
answer
helpful?
Yes
No
Friday, April 25th, 2014 AT 5:07 PM
Tiny
FIIFI
  • MEMBER
  • 5 POSTS
Please Sir, Which of the repair manuals would you recommend for me. To be able do good work.

Thanks
Was this
answer
helpful?
Yes
No
Saturday, April 26th, 2014 AT 3:19 AM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Factory manuals are the best but cost more but most of them areok
Was this
answer
helpful?
Yes
No
Saturday, April 26th, 2014 AT 6:25 AM
Tiny
FIIFI
  • MEMBER
  • 5 POSTS
Please there are lots of China products of the market which are not original they work for awhile and stop, could you please help recommend the best manual software of me. Even if I have to buy.

Thanks
Fiifi
Was this
answer
helpful?
Yes
No
Saturday, April 26th, 2014 AT 6:56 AM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
I really don't reccomend manuals try haynes or chilton those are the most popular
Was this
answer
helpful?
Yes
No
Saturday, April 26th, 2014 AT 7:12 AM

Please login or register to post a reply.

Sponsored links