Giving me the code for the sensor 1 bank 1

2006 NISSAN ALTIMA
190,000 MILES • 2.5L • 4 CYL • FWD • AUTOMATIC
Avatar
RAYMOND25840
  • MEMBER
  • 2 POSTS
I have replaced both O2 sensors, mass air flow sensor, throttle body, flex pipe, and my catalytic converter and I am getting the same code. I have erased it and put 2-3 drive cycles on my car and the check engine light keeps coming on. Giving me the code for the sensor 1 bank 1. Do I have to do the idle re-learn again or drain the ecm? I don't know what else could be left to do to fix this problem.
Oct 27, 2015 at 5:21 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
send the code it may be a blown fuse as some have fuses underhood or a poor connection or short
Oct 27, 2015 at 6:11 AM
Advertisement
Avatar
STRAILER
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 54,162 POSTS
Yes, it is fuse #8 in the fuse panel on the left side of the dash which runs the oxygen sensor heater, here is a guide to help and the fuse locations:

https://www.2carpros.com/articles/how-to-check-a-car-fuse

That should fix the problem. Check out the images (below). Let us know if you need anything else.
Image (Click to enlarge)
Attached Media
Jan 23, 2024 at 4:38 PM