BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
What is the best way to loosen the hub/spindle nut to access the CV joint
2003 HYUNDAI SANTA FE
Have been trying to loosen this nut, using WD40, is it safe to use heat? What can we do to get this nut off of the car?
have the same problem?
Sunday, December 18th, 2011 AT 4:23 PM
I'll use heat, WD40 and hit it with an impact wrench
Sunday, December 18th, 2011 AT 4:35 PM
I would be very careful with the heat if you are not planning on replacing the hub bearing. A strong impact gun is usually all that is needed.
Please consider a donation if we helped you
Sunday, December 18th, 2011 AT 5:18 PM
to post a reply.
Related Spindle Nut Questions
Brakes Are Shaking When Applied
My Husband Has A Santa Fe And It Has Been Shaking And When You Go To Put On The Brakes It Shakes Like You Would Not Believe. He Took It To...
Coil Springs Are Creaking
My Coil Springs Are Creaking. Problem Is The Spring Itself Is Not Attached To Any Suspension Parts, I.E The Front Struts Or The Rear...
Raul Ivan Sanchez
When I Drive It Feels Like The Wind Is About To Blow My Suv Over Is There Anything To Prevent That
2001 Hyundai Santa Fe Rear Driver Suspension
Its In The Rear Drivers Side. My Rear Suspension Spring Is Hanging. I Cant Seem To Be Able To Get A Straight Answer, Is It A Lower Control...
Ask a Car Question. It's Free!
Brake Pad/Rotor Replacement Toyota Tacoma
Brake Pad/Rotor Replacement Chevrolet
Front Brake Pad/Rotor Replace Chevy Avalanche
Find a car manual for your car
© 1999 - 2017 2CarPros, Inc.