I own a 2003 ford expedition 4.6 2wd the idle surges up and down and is idleing high. Replaced the idle air control unit and maf sensor and have taken off the throttle body and cleaned it. I have disconnected the idle air control unit and it runs fine. I dont know where to go from here any suggestions !
SPONSORED LINKS
Do you
have the same problem?
Yes
No
Sunday, September 16th, 2012 AT 7:45 PM
2 Replies
ASEMASTER6371
EXPERT
Runs fine? The idle is very low about to stall? Thats where it should be with it disconnected.
I would look around for a vacuum leak. Pcv hose is real common
Roy
Was this
answer
helpful?
Yes
No
Sunday, September 16th, 2012 AT 7:55 PM
DYNAMATECH
MEMBER
I would look into the throttle position sensor. I have had that problem a lot with fords. Good luck!