SPONSORED LINKS

2002 Ford Taurus engine stumbles and dies

Tiny
LARRYW64
  • MEMBER
  • 2002 FORD TAURUS
  • 3.0L
  • V6
  • FWD
  • AUTOMATIC
  • 102,000 MILES
Engine stumbles and dies when throttle is opened to +1500 rpm then closed quickly in Park or neural.
Replaced plugs, wires, air & fuel filters, fuel pump. Recently passed CA smog certification with low emissions readings.
Tuesday, July 1st, 2014 AT 12:51 PM

11 Replies

Tiny
WRENCHTECH
  • MECHANIC
  • 20,758 POSTS
What brand of plugs did you use? Should be Motorcraft only NEVER BOSCH.

First eliminate all vacuum or air leaks in the system. You may have a bad IAC ( idle air control) but try cleaning the throttle body first. Remove the intake snorkel, have someone hold the throttle wide open for you and scrub the back side of the throttle plate and surrounding bore with an old tooth brush and some carb cleaner. Be sure to spray some into the small holes next to the throttle plate. That should help stabilize the idle. If it still has a problem, replace the IAC.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, July 1st, 2014 AT 1:49 PM
Tiny
LARRYW64
  • MEMBER
  • 9 POSTS
Installed Motorcraft plugs, throttle body is black inside. Will clean. Is there any test I can do for the IAC?

Thanks,

Larry
Was this
answer
helpful?
Yes
No
Tuesday, July 1st, 2014 AT 2:25 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,758 POSTS
Not really. It's probably just not responding fast enough.
Was this
answer
helpful?
Yes
No
+1
Tuesday, July 1st, 2014 AT 2:30 PM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Try cleaning throttle plate on both sides and iac hole with choke cleaner.
Was this
answer
helpful?
Yes
No
Tuesday, July 1st, 2014 AT 3:12 PM
Tiny
LARRYW64
  • MEMBER
  • 9 POSTS
Thanks Hmac300, I'll see if that works.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, July 1st, 2014 AT 5:28 PM
Tiny
LARRYW64
  • MEMBER
  • 9 POSTS
Hi Wrenchtech, Then I replace the IAC? I think I found a hose going the transition piece from the throttle body to the air filter that's not real snug.
Thanks for your help, hope this works.
Was this
answer
helpful?
Yes
No
Tuesday, July 1st, 2014 AT 5:32 PM
Tiny
LARRYW64
  • MEMBER
  • 9 POSTS
Replaced the IAC and a vacuum line. Engine seems to be operating normal now. Thanks for your help.
Was this
answer
helpful?
Yes
No
Tuesday, July 8th, 2014 AT 8:19 AM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,758 POSTS
You're welcome.
Was this
answer
helpful?
Yes
No
Tuesday, July 8th, 2014 AT 8:27 AM
Tiny
LARRYW64
  • MEMBER
  • 9 POSTS
New issue after replacing the IAC, went for a test drive. The engine is idling at 1500 rpm's in drive after driving about 1/8 mile, engine at operating temp. I put it in park and idle went to 2000 rpm until rapid throttle open/close. Then it dropped to 800 rpm.

Any suggestions? I disconnected the battery but haven't reconnected it yet.

Thanks,
Larry
Was this
answer
helpful?
Yes
No
Tuesday, July 8th, 2014 AT 1:00 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,758 POSTS
You can try that with the battery but it sounds like you may have gotten a defective unit.
Was this
answer
helpful?
Yes
No
+1
Tuesday, July 8th, 2014 AT 2:02 PM
Tiny
LARRYW64
  • MEMBER
  • 9 POSTS
Appreciate the info. Back to NAPA.

Thank you,

Larry
Was this
answer
helpful?
Yes
No
Tuesday, July 8th, 2014 AT 5:15 PM

Please login or register to post a reply.

Related Engine Hesitate Content

Vacuum Leak Test and Repair
VIDEO
Vacuum Leak Test and Repair
Instructional repair video
Hesitation
GUIDE
Hesitation
An engine hesitation is an interruption of continuous power during acceleration. When a engine is hesitating it will cause the car to lunge or surge which will cause a...
VIEW MORE

Sponsored links