2001 Crysler 3.8 No Start, No Injector Pulse, Spark Ok, Fuel Ok

Tiny
MOD70XTR
  • MEMBER
  • 2001 CHRYSLER TOWN AND COUNTRY
  • 3.8L
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 136,000 MILES
We have a 01 T & C, 3.8 engine. Cranks, but no start. Good spark, good fuel pressure.

Injector pulse reads 0.0 on scanner. Neither wires on number 6 injector have power, with key on, engine off (#6 is about the only injector you can pull the pigtail on, without pulling the upper plenum).

The only code, is a P0106, MAP sensor out of range.
Do you
have the same problem?
Yes
No
Thursday, March 31st, 2016 AT 9:09 AM

9 Replies

Tiny
HMAC300
  • EXPERT
The map asensor may cause a no start but try resetting security system if no manual look online for your car on how to do it.
Was this
answer
helpful?
Yes
No
Thursday, March 31st, 2016 AT 9:38 AM
Tiny
MOD70XTR
  • MEMBER
Repaired the MAP sensor ground, code P0106 gone. Can not find a way to reset security system in our Snapon Verus scanner. 14.2 update.

Supplied battery voltage to brown/white injector wires. No pulse on injectors, & still 0.0 pulse width.
Was this
answer
helpful?
Yes
No
Thursday, March 31st, 2016 AT 10:11 AM
Tiny
HMAC300
  • EXPERT
Look online instead of in scanner for security reset. I think on a Chrysler product it's to lock door and unlock on driver's side, not sure though
Was this
answer
helpful?
Yes
No
Thursday, March 31st, 2016 AT 12:01 PM
Tiny
MOD70XTR
  • MEMBER
We have tried all the lock/unlock procedures, in every door. Nothing has changed. 0.0 injector pulse on scanner. Will not light a Noid light.

We also believe it has some type of theft code. Red security light, on dash, constantly blinks. But we can not find any type of theft code, with our scanner. And we can't find any information; other than the lock/unlock procedure; to clear a theft code.
Was this
answer
helpful?
Yes
No
Thursday, March 31st, 2016 AT 1:08 PM
Tiny
HMAC300
  • EXPERT
The security is in the key so try another key if you have one. It is very important to not have anything magnetic near or touch ignition switch otherwise it screws it up. If you don't have another key you'll have to get it scanned by a pro so he can fix security system problem.
Was this
answer
helpful?
Yes
No
Thursday, March 31st, 2016 AT 5:59 PM
Tiny
MOD70XTR
  • MEMBER
This system doesn't have the gray key, with the transponder in it. It has the black key, which is just a regular key. So; if the system is working properly, the way to disarm the security system, should be to lock, & unlock one of the doors.

That does not work.
Was this
answer
helpful?
Yes
No
Thursday, March 31st, 2016 AT 7:13 PM
Tiny
HMAC300
  • EXPERT
Then it needs to be scanned to see what is wrong with it and why it's engaged.
Was this
answer
helpful?
Yes
No
Friday, April 1st, 2016 AT 6:59 AM
Tiny
MOD70XTR
  • MEMBER
We put a Snapon Verus on it. It doesn't show any theft codes.
Was this
answer
helpful?
Yes
No
Friday, April 1st, 2016 AT 7:27 AM
Tiny
HMAC300
  • EXPERT
No idea what to tell you then I have no other comments or suggestions
Was this
answer
helpful?
Yes
No
Friday, April 1st, 2016 AT 8:12 AM

Please login or register to post a reply.

Recommended Guides