Wiring speedometer sensor plug?

FENSHOME

MEMBER
2000 TOYOTA LANDCRUISER
6 CYL
4WD

I have a Toyota HZJ97R 4X4 landcrusier and the 3 wires have been pulled out of the speed sensor at the gearbox. Can anyone tell me how the 3 wires should go back in the plug, ie. The colours and position in plug.

Kim

Monday, September 29th, 2014 AT 11:13 PM

6 Replies

MHPAUTOS

MECHANIC
31,937 POSTS

See pic, the pins should be numbered 1,2,3 and I have included the entire wiring diagrams for the transmission and the VSS. Also, this guide can help you test the connections.

https://www.2carpros.com/articles/how-to-check-wiring

Check out the images (below). Let us know how it goes

Images (Click to make bigger)

Was this

answer

helpful?

Yes

-2

Tuesday, September 30th, 2014 AT 4:22 AM

FENSHOME

MEMBER
4 POSTS

Hi

I greatly appreciate your assistance.

Kim

Was this

answer

helpful?

Yes

Tuesday, September 30th, 2014 AT 2:16 PM

FENSHOME

MEMBER
4 POSTS

Hi

Have a further question. In relation to the plug which is pin 1, 2, & 3 as not numbered when I look at it? I have no bits of the cable left on the plug side as it was pulled completely out.

Was this

answer

helpful?

Yes

Tuesday, September 30th, 2014 AT 7:31 PM

MHPAUTOS

MECHANIC
31,937 POSTS

The plugs are normally numbered as if looking front on and left to right. Here is a diagram I found which should be the VSS connector. Check out the images (below). Let us know if you need anything else.

Image (Click to make bigger)