HOW DO I LOCATE THE COOLANT DIVERTER VALVE? CAR ...

  • Tiny
  • Anonymous
  • 2000 Lincoln LS
  • 135,000 miles

How do I locate the coolant diverter valve? Car does not blow heat but it does blow cold air

Wednesday, October 31st, 2012 AT 11:29 PM

1 Answer

  • Tiny
  • ASEMaster6371
  • Expert
  • 25,502 posts

Disconnect the battery ground cable. Refer to battery.
Drain the radiator. For additional information, refer to Cooling System.

Disconnect the connector located at the end of the coolant valve harness pigtail.

Disconnect the three quick-disconnect couplings from the coolant control valve hoses.

NOTE: The top heater hose has a green identifying mark to match the hose on the dual coolant flow valve. If mark is not visible, identify the hoses for location. This will aid in the correct installation of the hose assemblies.
Hose assemblies shown with components removed for clarity.

Raise the vehicle. For additional information, Refer to Maintenance/Service and Repair.

Remove the coolant valve assembly mounting bolt and the nut.
Raise the valve and disconnect the coolant supply and return lines.

Remove the bolts and remove the coolant valve mounting bracket.
To install, reverse the removal procedure.

Lubricate the coolant hoses with Merpol meeting Ford specification ESE-M99B144-B or plain water.

Was this
answer
helpful?
Yes
No
Thursday, November 1st, 2012 AT 2:21 AM

Please login or register to post a reply.

Similar Questions