2000 Crown vic

Tiny
ALIVIA601
  • MEMBER
  • 2000 FORD CROWN VICTORIA
  • AUTOMATIC
How do I change a fuel injector on a 2000 crown victoria police intercepter
Do you
have the same problem?
Yes
No
Monday, March 14th, 2011 AT 8:15 AM

2 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
For what Liter/CID engine, we need to know this
Was this
answer
helpful?
Yes
No
Monday, March 14th, 2011 AT 9:16 AM
Tiny
WAY2OLD
  • MECHANIC
  • 195 POSTS
As this is a CVPI, it has the 4.6L engine. First, what leads you to believe the injector is faulty? There is a fuel rail that needs to be removed. First disable the fuel pump. You can unplug the inertia switch in the trunk or the fuel pump relay if you want. Then start the vehicle and let it run until it dies. There are 2 little screws that hold the fuel rail to the intake. The fuel rail is an aluminum rail that holds the injectors in place. Pull up on the fuel rail on the side the bad injector is. More than likely more injectors will come out with the one you want to remove. You need to lubricate the "O" rings on the injectors upon re-installation. Push the fuel rail down evenly on all the injectors. Install mounting bolts. Make the fuel system work again. Turn the key to the run position 3 or 4 times and check for fuel leaks. Then start vehicle if there are no fuel leaks.
Was this
answer
helpful?
Yes
No
+11
Monday, March 14th, 2011 AT 11:33 PM

Please login or register to post a reply.

Sponsored links