Do I need a new transmission or can I replace the shift solenoids in question.

Tiny
CHRIS THOMPSON
  • MEMBER
  • 1999 MERCURY COUGAR
  • 137,000 MILES
Or does it have a transmission module that could be bad? My car is very sluggish taking off, like it is taking off in high gear. I do not hear it or feel it shift, even if I do it manually. And going down the highway @ 60 mph, my tach is showing over 3000 rpm's. Which I know that is high for that speed. My overdrive button does not work at all. I bought a obd2 Diagnostic tool(INNOVA 3100). Which gives me 5 codes. Codes as followed: (P0743) Torque converter clutch solenoid Circuit electrical, (P0750) Shift Solenoid A, (P0755) Shift Solenoid B, (P1744) Torque Converter Clutch Solenoid Circuit Performance, (P0190) Fuel Rail Pressure Sensor. Then on the KOEO test it shows as followed: (P1519) Intake Manifold Runner Control Stuck Closed (Bank 1), (P0713) Transmission Fluid Temperature Sensor A Circuit High Input, (P0743), (P0750), (P0755), again. Then (P1746) Pressure Control Solenoid A&B Open Circuit, and finally(P1000) OBD Systems Readiness Test Not Complete.
Friday, December 2nd, 2011 AT 3:27 AM

1 Reply

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,355 POSTS
All of the parts mentioned are replaceable. So, yes, you can replace them. However, chances are they are not all bad. If you were to reuse the sensors you have now in a new trans, the same thing would happen. I would suggest checking the TCC first. It can cause a few of the other codes you are getting to show up.
Was this
answer
helpful?
Yes
No
Friday, December 2nd, 2011 AT 3:31 AM

Please login or register to post a reply.

Sponsored links