1998 Chevrolet S-10 starting

AJMOFFETTE

MEMBER
1998 CHEVROLET S-10
2.2L
4 CYL
2WD
MANUAL
70,000 MILES

When I turn the key to start truck you cn her starter engadge to start truck but all it does is twitch the motor and not turn it completely over flywheels in good shape

5 Replies

WRENCHTECH

EXPERT

Put a socket on the crankshaft and see if you can turn the motor by hand.

If you can, then you have starter or battery issues.

If not, then your motor is locked up for some reason.

SPONSORED LINKS

Was this

answer

helpful?

Yes

No

Saturday, November 7th, 2015 AT 3:07 PM

AJMOFFETTE1121

MEMBER

Thee motor is not locked up as I said it starts and runs fine when you push start it

Was this

answer

helpful?

Yes

No

Sunday, November 8th, 2015 AT 7:16 AM

AJMOFFETTE1121

MEMBER

Sorry I didn't say that but yea it starts and runs when push started

Was this

answer

helpful?

Yes

No

Sunday, November 8th, 2015 AT 7:20 AM

WRENCHTECH

EXPERT

Have the battery tested first to make sure it has full power capacity and then make sure all the connections are good, especially the side posts before condemning the starter.

Read the battery voltage while someone tries to start it to see if it drops significantly to indicate a good connection. The battery shouldn't drop below about 10v during cranking. If it doesn't drop at all, that would indicate a bad connection somewhere.

Was this

answer

helpful?

Yes

No

Sunday, November 8th, 2015 AT 7:23 AM

AJMOFFETTE1121