JEEP WINDOW MOTOR

  • Tiny
  • knipe_92@yahoo.com
  • 1997 Jeep Cherokee
  • 6 CYL
  • 4WD
  • automatic

How to change window motor in jeep

Thursday, August 18th, 2011 AT 7:12 AM

1 Answer

  • Tiny
  • rasmataz
  • Member

POWER WINDOW MOTOR
NOTE: Power window motor and mechanism is integral to power window regulator. If power window motor or mechanism is faulty, window regulator assembly must be replaced.

Removal & Installation (Front Window Motor)
Disconnect negative battery cable. Remove front door trim panel. See DOOR TRIM PANEL. Pry up on weatherstrip corner and remove inner and outer weather-stripping. See Fig. 4. Put window in up position.
Remove bolts securing glass to regulator assembly. Carefully lift glass upward and out of door. Loosen regulator assembly mounting bolts/nuts. See Fig. 5.
Lift regulator assembly upward to release assembly from key hole slots. Remove regulator assembly through access hole in inner door panel. To install, reverse removal procedure.

Was this
answer
helpful?
Yes
No
Thursday, August 18th, 2011 AT 11:49 AM

Please login or register to post a reply.

Similar Questions