SPONSORED LINKS

Oil pressure dropping when idle is low

Tiny
SCJELDRETH
  • MEMBER
  • 1996 CHEVROLET S-10
Have a 1996 chevy s10 with cfi fuel injection, oil pressure drops to zero on gauge at low rpm but no rattle or knock, does not affect drive-ability so switch is not cutting power to fuel pump, what could cause this?
Oil pressure comes back on acceleration, no engine noise in valve train or block, no loss of fuel pressure
SPONSORED LINKS
Thursday, October 27th, 2011 AT 6:22 PM

2 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,304 POSTS
Chances are the oil sending switch is bad. To check, you need to get a mechanical oil pressure gauge. Most parts stores will lend them to you. It will screw into the engine block where the oil switch is located. When you start the engine, you will see exactly what the pressure it. My guess, the switch is bad.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Thursday, October 27th, 2011 AT 8:13 PM
Tiny
SCJELDRETH
  • MEMBER
  • 2 POSTS
That was my guess too, according to schematic the truck will not run without that that three wire oil pressure/ fuel pump switch hooked up so how do I check it with a mechanical gauge?
Was this
answer
helpful?
Yes
No
+5
Thursday, October 27th, 2011 AT 9:24 PM

Please login or register to post a reply.

Related Oil Low Pressure Content

Oil Pressure Low
GUIDE
Oil Pressure Low
Engine oil is used to cool and lubricate bearing and machined surfaces. Without oil pressure an engine will experience extreme internal engine damage due to heat caused by...
VIEW MORE

Sponsored links