1995 Oldsmobile Cutlass '95 Supreme wire problem

RAUL379

MEMBER
1995 OLDSMOBILE CUTLASS
3.1L
6 CYL
FWD
AUTOMATIC
120,000 MILES

The car is having starting problems, the lights and engine is fine and so is the battery. I discovered that when I open the passenger side door I can turn on the car and it runs but for a while, I'm guessing its something with the alarm system because my father-in-law did something to it. After it turns off I do the same thing and it wont start back up, even if I open the driver side it does not want to start or anything. It makes no noise whatsoever and my daughters friend said it might have something to do with the starter but it seems to be fine. I need help please.

Saturday, February 14th, 2015 AT 12:12 PM

1 Reply

HMAC300

MECHANIC
48,601 POSTS

It sounds like the starter could be the problem if you do not have a security light flashing, Let's check for power at the starter motor trigger wire, this guide can show you how.

https://www.2carpros.com/articles/starter-not-working-repair

Upon removal of starter, note if any shims are used. If shims are used, they should be reinstalled in their original location during installation. If starter is noisy during cranking, remove one .015 inch double shim or add one .015 inch single shim to the outer bolt. If starter makes a high pitched whine after firing, add .015 inch double shims until noise ceases.

1. Disconnect battery negative cable.
2. Raise and support vehicle, then remove nut from brace at A/C compressor.
3. Disconnect wiring from front of frame.
4. Remove dust cover attaching bolts, then dust cover.
5. Remove all electrical wiring from starter, then remove starter from vehicle.
6. Remove starter attaching bolts, then lower starter.
7. Reverse procedure to install.

Here is the location of the starter and how to change it out in case you need it. Right side of the engine near the transmission.

Was this

answer

helpful?

Yes

No

Saturday, February 14th, 2015 AT 1:05 PM