No Start No Spark

Tiny
ICEMAN1956
  • MEMBER
  • 1994 LINCOLN CONTINENTAL
  • 189,000 MILES
No start - no spark - Replaced pip distributor - ign. Module - computer - coil - dist. Cap - rotor button - wires - plugs - have B+ voltage at coil - ign. Module - computer
Thanks Robert
Do you
have the same problem?
Yes
No
Thursday, December 22nd, 2011 AT 1:37 PM

5 Replies

Tiny
RASMATAZ
  • MEMBER
Put a test light on the negative coil terminal have helper crank engine over is the test light blinking?
Was this
answer
helpful?
Yes
No
Thursday, December 22nd, 2011 AT 3:19 PM
Tiny
ICEMAN1956
  • MEMBER
Have tried that but have no ground back through the coil Thanks Robert
Was this
answer
helpful?
Yes
No
Thursday, December 22nd, 2011 AT 7:00 PM
Tiny
RASMATAZ
  • MEMBER
Check and test the distributor pick-up coil
Was this
answer
helpful?
Yes
No
Friday, December 23rd, 2011 AT 12:23 AM
Tiny
MIKE.KITZ
  • MEMBER
  • 1994 LINCOLN CONTINENTAL
  • 3.8L
  • V6
  • 2WD
  • 81,000 MILES
Ready to drive this car into the Delaware river. Will not start after new fuel regulator, plugs and wires are installed? Need to check firing order?
Was this
answer
helpful?
Yes
No
-1
Wednesday, November 1st, 2017 AT 7:41 PM (Merged)
Tiny
JACOBANDNICKOLAS
  • EXPERT
Are you getting spark and fuel to the engine? Will it start for a couple seconds if you use starting fluid?
Was this
answer
helpful?
Yes
No
Wednesday, November 1st, 2017 AT 7:41 PM (Merged)

Please login or register to post a reply.

Recommended Guides