MY CRUISE CONTROL SWITCH BROKE. HOW DO I GET IT OUT TO REPLACE IT?

  • Tiny
  • pstrmc
  • 1988 Buick Electra
  • 113 miles

I got the switch unplugged, but I don't see any wat to release the lever from the multi-function switch. How do I get it off?

Do you
have the same problem?
Yes
No
Wednesday, October 5th, 2011 AT 2:48 AM

6 Replies

  • Tiny
  • Jacobandnickolas
  • Expert
  • 68,409 posts

Isn't this all one piece? The signal switch and the CC switch? I'm trying to picture how they were in 88.

Was this
answer
helpful?
Yes
No
Wednesday, October 5th, 2011 AT 3:11 AM
  • Tiny
  • pstrmc
  • Member

The CC Switch is on the end of the wand/lever. After some research, I need to clarify that the wand/lever goes into the turn signal switch instead of directly into the multifunction switch. I don't know if the wand/lever can be removed from the signal switch independently or if the whole wand and signal switch have to be replaced together.

Was this
answer
helpful?
Yes
No
Wednesday, October 5th, 2011 AT 4:57 PM
  • Tiny
  • pstrmc
  • Member

Yes.

Was this
answer
helpful?
Yes
No
Wednesday, October 5th, 2011 AT 5:06 PM
  • Tiny
  • Jacobandnickolas
  • Expert
  • 68,409 posts

I believe it is all one switch.

Was this
answer
helpful?
Yes
No
Wednesday, October 5th, 2011 AT 8:57 PM
  • Tiny
  • pstrmc
  • Member

I got it figured out. The lever pulls out of the turn signal switch with a little effort. There is an indent around the rod that goes into the switch. This is under pressure to hold it in place. Thanks for the responses.

Was this
answer
helpful?
Yes
No
Friday, October 7th, 2011 AT 3:04 PM
  • Tiny
  • Jacobandnickolas
  • Expert
  • 68,409 posts

Glad you got it taken care of.

Was this
answer
helpful?
Yes
No
Saturday, October 8th, 2011 AT 3:49 AM

Please login or register to post a reply.

Similar Questions