KIA OPTIMA ENGINE

Found 223 results

Select a filter to limit the results

Symptoms Balance Shaft Camshaft Computer Crankshaft Cylinder Head Flywheel Harmonic Balancer Intake Manifold Knock Sensor Mass Air Flow Sensor Mount Oil Oil Change Oil Filter Oil Pump Oxygen Sensor Piston Replace/Remove Serpentine Belt Starter Throttle Body Timing Belt Timing Chain Tune-up Vacuum Hose Diagram

Engine Will Not Start?

Had A Bad Crankshaft Sensor And Replaces It, It Is A Manual So Before I Found Out It Was Bad I Has To Push Start It. So I Changed It It...

Asked by mikewhiteguy22 ·

16 ANSWERS

68 IMAGES

2006

Turn Over an Engine by Hand | Bar Over

VIDEO

Turn Over an Engine by Hand | Bar Over

Instructional repair video

Code Reading

A check engine light, also known as a service engine light, or a MIL (malfunction indicator light) is designed to let you know there is a problem with one of your car's...

Timing Marks

Replaced Timing Belt, Set All Timing Marks On All Sprockets, Turned Engine For Two Full Revolutions And All Timing Marks Were Back To...

Asked by James bussell ·

5 ANSWERS

33 IMAGES

2005

Camshaft And Balance Shaft Timing Marks

I Am Replacing The Timing Belt And Balance Shaft Belt As Part Of A Head Repair Due To Balance Shaft Belt Breaking. Can You Help?

Asked by Bigmoose ·

44 ANSWERS

10 IMAGES

2004

Crankshaft Position Sensor Location And Replacement?

Where Is The Crankshaft Position Sensor Located And How To Change It?

Asked by John Jay GO Thomas ·

15 ANSWERS

11 IMAGES

2006

Engine Stalls While Driving?

My Car Cut Off On Me While I Was Driving So I Change The Starter And It Worked For About Two Weeks Then Start Doing It Again. However, This...

Asked by Jonpinner30 ·

24 ANSWERS

15 IMAGES

2015

Crank But Will Not Start

I Went In The Store Came Back Out Car Would Not Start. Turns Over But Will Not Start. Radio And Power Windows Will Not Work. No Lights On...

Asked by marthajtulsa ·

1 ANSWER

18 IMAGES

2006

P1000 Trouble

A P1000 code is designed to inform the driver the engine management system is not working to it's full potential. When in open loop, the powertrain management system is...

Code P0340, Will Not Start

My Car Was Borrowed By My Brother And He Said The Car Just Suddenly Shut Off On Him While Driving. Had It Towed Home And Found A P0340 Code...

Asked by AppleUp ·

3 ANSWERS

19 IMAGES

2014

Camshaft Sensor Location?

Rear Bank Of Plugs Do Not Fire. Engine Tester Said Rear Cam Sensor Failure. I Have Not Been Able To Find The Location Of The Sensor.

Asked by Todd Beaulieu ·

20 ANSWERS

14 IMAGES

2007

Starter Replacement And Location ?

What Has To Be Removed To Get A Starter Out On A 2009 Optima?

Asked by Anonymous ·

23 ANSWERS

17 IMAGES

2009

Crankshaft Position Sensor Location Needed

I Have A Dtc For The Crankshaft Position Sensor. I Have A 2006 Body But Have Installed A Engine From A 2008 Kia Optima 2.4. My Question Is...

Asked by mvann74 ·

9 ANSWERS

5 IMAGES

2008

Ask a new Kia Optima question

Ask a Car Question. It's Free!

© 1999 - 2025 2CarPros, Inc.