FORD ENGINE

What Is The Special Tool Used To Install The Front Main Seal Into The Timing Chain Cover?

I Watched A Video On Timing Chain Replacement On The 5.4 3v, It Said I Have To Make Sure I Get Both Cams At The 12o'clock Position Then...

How Do I Change The Crankshaft Position Sensor? I See Where It Is. Do I Need To Remove Anything To Get It Out And Put The New One In?

Hello, I’m Currently Building My Stock 302 Engine. I’m Going With Trick Flow Forged Pistons And I Was Wondering If I Can Use My Stock...

My Car Will Turn Off When Driving, So Far Only In Town Driving. I Pull Over And It Will Re-start. Runs And Idles Fine. I Have Replaced...

My Car Turns Over, Just Clicks Power To Dash And Lights Nothing Else.

Noisy And Code Reader Says Cam Phasers. Which Has To Do Will Oil. So, I Changed My Oil Months Before, But I Never Reset The Change Oil...

My Ranger Is Getting A Po133 Error On My Elm Scan Tool, And The Check Engine Light Comes On A While After I Clear The Codes. I Have...

My Wife Drives A 1999 Ford Taurus. After Driving The Car Will Not Start Back Up, And The "theft" Light On The Dash Board Flashes...

After Diving My 99 Explorer Long Distances In Weather Hotter That 85 Deg. F, The Act Like There Is No Fuel, And It Run Bad. I Have To Let...