2001 Chrysler Sebring Repair Question
Topics covered: Clutch, Cooling fan, Valves.
Mileage: 8,000 miles.
Mileage: 8,000 miles.
Asked on June 17, 2012
Can you help me with a/c problem
High pressure keeps climbing low side
clutch wont engage
jumped term 30+87 on a/c relay
clutch engaged blowing cold air
high side gauge starts to climb
and fluctuate
low side starts climbing also
last compressor did same
till it safety high pressure blow
put on another after evacuating
vaccumed 3/4 hr
same problems
clutch wont engage
jumped term 30+87 on a/c relay
clutch engaged blowing cold air
high side gauge starts to climb
and fluctuate
low side starts climbing also
last compressor did same
till it safety high pressure blow
put on another after evacuating
vaccumed 3/4 hr
same problems
Answer
Replied on June 17, 2012
make sure the cooling fans operates.
fluctuating high side usually indicates bad reed valves in the compressor.
was the compressor new or used?? did you change the dryer?? did you change the H valve??
Roy
Replied on June 17, 2012
hi roy
it was a used a/c comp i installed
and i did not change dryer
and valve
the fans did come on when
i bypassed a/c relay
i,ll change those 2 parts with
new ones
and get back too you
thx roy
Replied on June 17, 2012
good luck. make sure you install the exact amount of freon
Roy