Engine cranks but won't start

Ive ran the bronco for nearly a year with no problems, a few days ago I was driving home and the engine began to sputter like it was low on fuel, I nused it along and made it home sputtering. I parked it overnight and tried to start it the next morning with no luck, it turns over but will not fire. The fuel pum, p is only 6 months old as are the fuel lines, and I can smell fuel when it turns over, I have not yet checked for spark or compression but what do you think the problem is? And what do I do to get her running again?

Did u get it started?
If I can help I have a 91 with the 302 and it kinda did the same thing. Ive replaced the o2 sensor plugs wires distributor rotor and idle air control sensor. The plugs were fouled from a rich mixture so I tried the o2 plus etc fired right up idled poorly and kept stallin. Just changed the idle air conntrol sensor and idled good took it out ran a hell of a lot better. Check engine light came on got it home idled terrible again. I was told it might be the throttle positioning sensor or drive idle sensor. Im no!Mechanic so im just advice if you could help me out with any info id b appreciated

Replaced pcm replaced fuel pump
no start at times I feel that it may have somthing to with anti theft but cant pin it down
no codes shown when tested
I work at a ford dealer we are just mystified on whats going on
fuel pump was shot we know that so we replaced it still had a no start problem so we replaced the pcm
somtimes it starts and somtimes it dosent
any help would be appreciated.
Thank you
Ed

Cranks has fuel pressure wont start

5.8l
has spark has fuel pressure
sat morning no start with doors closed used key fobs to lock and unlock and tryed to start fired right up went ice fishing for the morning came to start no
start cycled locks and unlocks for about 6 times and fired up

I have a 1995 ford bronco I replaced the maf sensor and the idle air control valve but the truck will not run with the maf sensor plugged in if I take the hose off or unplug the maf sensor it runs fine

Thanks we will try it

Yes it was the original problem and it did not fix it

It only brings up a code when maf is unplugged and I cannot get a reading because the truck will not run with the maf sensor plugged in

My truck starts occasionally. It will crank but not turn over the other times. I have replaced: battery, spark plugs, plug wires, dist. Cap/rotor, starter, starter relay, fuel pump relay, powertrain control system relay, negative battery cable, coil pack, and the ignition starter switch. I think it might be electrical because when I leave the key on the on position and wiggle wires under the hood I hear the fuel pump relay reset and thats when it starts. But sometimes it will stop running while I'm driving. Somebody told me it could be the fuse/relay box under the hood could be corroded. Also could you tell me what those 4 relays under the hood next to the fuse box? I cant find what they control anywhere.

Yes it has a new maf sensor