THANK YOU , i have reviewed your site time to time, i found it very interesting, and helpfull , hope you can help with this mercedes question , as stated i have flushed feul system with new feul (prem) i have pressure up to feul dist,

Response from Cbones
3 questions asked

ok, you have good fuel pressure. do you have a noid light to see if the injectors are being commanded to fire??

the injectors may have varnish build up from lousy fuel and may be clogged

Roy.

Answered by ASEMaster6371 (expert)
24,852 answers provided

feul pressure is running about 62lbs, i just got set of noid lights today, will try in morning, thank you , i have preesure to cold start valve, but none at feul dist,coming out, but have not tried depresing feul pedal, i will check noids early in morning, car has set for two and half yrs at repair shop, that is why i flushed feul system and new feul filter, Boy the old feul Stunk!, but i flushed tank good feul strainer is clean and filter replaced ran good feul thruogh all feul lines all the way to feul dist, thank you again , i will be back in touch later friday

Response from Cbones
3 questions asked

i just hope the distributor has not got a bad valve.

lift up on the arm to see if it fires up

Roy

Answered by ASEMaster6371 (expert)
24,852 answers provided

when you say lift up are you speaking of throttle body type peice , should i lift the inside peice, not deprese it, im not very familar with type feul system but if you say lift up i will in morning thanks again

Response from Cbones
3 questions asked

good afternoon asemaster6371, as you advised i lifted the plate and car started , after a couple seconds it died , but i was amazed that it actually started, i may have been a bit to carefull before , im going to check everything over before i continue any farther i hear a little wine in feul pump , but it quits when it builds pressure ,as i stated it has set for a while almost two years looking at work order from the repair shop it was at, i was looking at intake manifold where injectors go in and noticed feul leaking around that area, im going to look it over good, these guys had the whole top end off for a while, i put head on and hooked everything up as book said , i am wondering if i can get some info on cold start valve, how it funtions , i have book and will study some more, Thank you for all your help, i need to see how feul dist works as well, THIS SITE IS A LIFE SAVER, i will be checking back in later , Again Thanks, C.BONES

Response from Cbones
3 questions asked

good job.. i believe you will be replacing the fuel distributor assembly

Roy

Answered by ASEMaster6371 (expert)
24,852 answers provided