Mechanics

MANUAL TRANS STARTS BUT STALLS AFTER TOUCHING THROTTLE

1990 Toyota Camry • 20,000 miles

Replaces spark plugs, wires, fuel filter, air filter. After starting even lightly taping on acceloerator vehicle stalls
Avatar
Robert Lamarche
October 15, 2011.




What do you have for fuel pressure


BMRFIXIT
Oct 15, 2011.
Is testing for fuel pressure the next step? I am not a tech. That is obvious since I am asking these questions. I have no experience testing for fuel pressure. I was hoping replacing a simple sensor or switch would solve this problem. What is the process for testing fuel pressure?


Tiny
Robert Lamarche
Oct 16, 2011.
This the page that shows how to check fuel pump and fuel pressure

http://www.2carpros.com/articles/how-to-check-fuel-system-pressure-and-regulator

as if it a sensor or switch need to check for codes
this is one way of RETRIEVING TROUBLE CODES

CAUTION:DO NOT enter self-diagnostic system until all basic engine checks (engine, fuel and spark) have been performed.

Verify CHECK ENGINE light circuit is operational.
Ensure battery voltage is above 11 volts and charging system is okay.
Engine must be at normal operating temperature.
Transmission/transaxle must be in Neutral or Park. Air conditioner and other accessories must be off.
Throttle valve must be closed (throttle position idle contacts closed).
Turn ignition switch to ON position with engine off.
Place jumper wire across "TE1" (or "T") and "E1" terminals in engine check connector. See Fig. below.

Count number of flashes from CHECK ENGINE light.
If system is operating properly (with no codes), CHECK ENGINE light will blink continuously and evenly.

NOTE:If CHECK ENGINE light stays on and will not blink codes, verify battery voltage is present at "TE1" (or "T") with key on and engine off. Ensure "E1" has continuity to ground or self-diagnostics will not work. If ground ("E1") is open, jumper "TE1" (or "T") to battery ground.

A trouble code will be identified by a .5 second flash on and off for the first number. A 1.5 second pause will occur followed by the second number.
If more than one code is stored, a 2.5 second pause will occur before second code is flashed. Once all codes have been displayed, a 4.5 second pause will occur and code(s) will repeat.
Trouble codes are given from smallest number code to largest number code. After codes are retrieved, remove jumper wire to exit diagnostic mode.
AD


BMRFIXIT
Oct 16, 2011.

AD