FORD CROWN VICTORIA THROTTLE BODY

Found 5 results

Select a filter to limit the results

Clean Throttle Position Sensor

Won't Stay Running

Car Cranks Fine When Cold. After Running Just A Few Seconds, It Will Shut Off. Have Replaced Mapp Sensor & Throttle Control Sensor. If I...

Asked by jerry vonier ·

9 ANSWERS

1 IMAGE

1985

FORD CROWN VICTORIA

Service a Throttle Body Housing Ford

VIDEO

Service a Throttle Body Housing Ford

Instructional repair video

Throttle Actuator Bore Service

Throttle Actuator Bore Service

The throttle bore or throttle actuator as they are called on newer cars is used to meter the engine air intake thus controlling the engine RPM and power output via the gas...

Sensors

Does A 1990 Ford Crown Victoria Lx Have Sensors For The Transmission If So Where And Where Is The Throttle Body Located For Same Vehicle....

Asked by valalston ·

1 ANSWER

1990

FORD CROWN VICTORIA

1984 Ford Crown Victoria Starting Fluid

Car Only Starts When I Use Starting Fluid In The Throttle Body. After That It Runs Fine All Day Until The Next Day. Then I Have To Use The...

Asked by reaper7_59 ·

1 ANSWER

1984

FORD CROWN VICTORIA

2004 Ford Crown Victoria Idle

The Car Has An Idling Down Problem When Warmed Up. Normal Cold Start Idle About 1500 Or So Rpm And Drops Down Gradually Cause It Is Of...

Asked by 04cvpi ·

4 ANSWERS

2004

FORD CROWN VICTORIA

How to Build a Ford 302 Small Block - Part 10

VIDEO

How to Build a Ford 302 Small Block - Part 10

Instructional repair video

Thermostat/ Ignition Switch/ Throttle Position Sensor

I Have A 1987 Crown Victoria Ltd, 5.0l, V8, 4 Door. Can You Give Me Details On How To Replace The Thermostat, Including Where It Is...

Asked by CVsForever ·

3 ANSWERS

1987

FORD CROWN VICTORIA

Ask a new Ford Crown Victoria question

Sponsored links

Ask a Car Question. It's Free!

SPONSORED LINKS

Online car repair manuals

Online car repair manuals

© 1999 - 2024 2CarPros, Inc.