SPONSORED LINKS

2002 Volkswagen TDI sensers

Tiny
WARNERJDW
  • MEMBER
  • 2002 VOLKSWAGEN TDI
  • 4 CYL
  • 2WD
  • MANUAL
  • 165,000 MILES
Drivers side of the car, end of the engine where the water hose hooks to the head there is three single wires and three sensers of some sort. My wires on two of the sensers have melted. What are these sensers and if they were bad would that melt the wires
SPONSORED LINKS
Tuesday, March 17th, 2009 AT 2:08 PM

2 Replies

Tiny
JAMES W.
  • MECHANIC
  • 2,395 POSTS
The three sensors you describe should be; cooling fan switch, temp gauge, and engine temp sensor. The only thing I can think of that would cause that kind of damage is a shorted sensor to ground compiled with an "over sized" fuse. Check your fuses.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, March 17th, 2009 AT 3:21 PM
Tiny
TDI-CANOLA-POWER
  • MEMBER
  • 3 POSTS
These are wires for the coolant heater, there are three of them on the drivers side of the engine, they heat the coolant on cold days when the engine can't produce enough heat. Get the coolant heater plugs checked out to make sure they are not bad
Was this
answer
helpful?
Yes
No
Sunday, September 27th, 2009 AT 5:44 PM

Please login or register to post a reply.

Related Cylinder Head Content

Blown Head Gasket Test Video
VIDEO
Blown Head Gasket Test Video
Instructional repair video
Cylinder Head Gasket Replacement
GUIDE
Cylinder Head Gasket Replacement
A cylinder head gasket is used to seal the combustion charge between the cylinder head the engine block, this gasket also controls the flow of coolant between the two as...

Sponsored links