SPONSORED LINKS

1991 Toyota Camry can't get the axle out of the transmissio

Tiny
R.RICHARDS31
  • MEMBER
  • 1991 TOYOTA CAMRY
Drive Train Axles Bearings problem
1991 Toyota Camry 4 cyl Front Wheel Drive 150000 miles

I had a bad CV joint and bought the assembley and got everything off but when I tried to pull the axle out of the transmission it only goes so far and stops. The new one looks like it has a metal ring that fits in a grove on the side that is susposed to go into the transmission. Is there somthing special you have to do to get it to come out? I pried and couln't get anywhere. Thanks for any information,

Ricky Richards
SPONSORED LINKS
Wednesday, October 1st, 2008 AT 12:48 AM

1 Reply

Tiny
DSPLC
  • MECHANIC
  • 220 POSTS
Same procedure as the topic below:

https://www.2carpros.com/forum/1999-toyota-camry-removal-of-cv-axel-vt192053.html

It is hard to get it out because the metal ring is the lock inside the transmission so that the axle will not slip out of the transmission.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, October 1st, 2008 AT 12:34 PM

Please login or register to post a reply.

Related Differential Axle Bearing Content

Axle Bearing and Seal Replacement Rear 3/4 and 1 ton
GUIDE
Axle Bearing and Seal Replacement Rear 3/4 and 1 ton
This guide is created to show you how to replace an axle seal and bearing on a 3/4 and 1 ton rear axle. Most trucks and SUV's use the same style of Dana rear end so this...
VIEW MORE

Sponsored links