torque Nm spec for camshaft pulley, composite intake and crank pulley needed?

2007 CITROEN BERLINGO

100,000 MILES • 1.6L • 4 CYL • 2WD • MANUAL

HENRIK77

MEMBER
2 POSTS
FOLLOW

Hello, I'm searching for torque nm tightening specs for the vehicle listed above 1.6 16v Tu5 NFU.
searching for camshaft pulley nm and composite intake nm and crank pulley nm.
Thanks, Henrik

Jun 15, 2024 at 9:52 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

STRAILER

CAR REPAIR CONTRIBUTOR
54,209 POSTS

here are the torque specifications you need:

camshaft pulley is 20 nm

The intake manifold is 13 nm

crankshaft pulley bolt is 40 nm, followed by an additional 60-degree angle tightening

Let us know if you need anything else.

Jun 15, 2024 at 11:11 AM

HENRIK77

MEMBER
2 POSTS

Thanks Ken.

Jun 15, 2024 at 3:22 PM

STRAILER

CAR REPAIR CONTRIBUTOR
54,209 POSTS

You are welcome, please use 2CarPros anytime we are here to help.

Jun 16, 2024 at 10:26 AM