Replaced blend door actuator and now it blows hot

Tiny
JOSHTJ0827
  • MEMBER
  • 2004 HONDA PILOT
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 160,000 MILES
I replaced my blend door actuator on my vehicle. The old one was making a clicking noise when going from cold to hot. After replacing the blend door actuator with the new one, it now blows completely hot and when I move the climate control knob to cold, it stays hot. What went wrong? I looked underneath when checking the actuator and the metal arm does move from left to right when changing the temperature.
SPONSORED LINKS
Do you
have the same problem?
Yes
No
Tuesday, April 26th, 2022 AT 12:36 PM

2 Replies

Tiny
JOSHTJ0827
  • MEMBER
Update: I was able to figure it out. I forgot to attach the piece that controls the vent to open and close!
Was this
answer
helpful?
Yes
No
Tuesday, April 26th, 2022 AT 6:06 PM
Tiny
JACOBANDNICKOLAS
  • EXPERT
Hi,

Thank you for the update. I'm glad to know it's fixed.

Please feel free to come back anytime in the future.

Joe
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Tuesday, April 26th, 2022 AT 7:55 PM

Please login or register to post a reply.

Related Blend Door Actuator Replace/Remove Content

Blend Door Actuator Replacement
GUIDE
Blend Door Actuator Replacement
Do you hear a ticking noise from your dash when the ignition key is on? Does your car heater blow cold or the air conditioner blow hot? These are signs that a blend door...

Sponsored links