1997 Nissan Altima car cuts off

Tiny
NEIL J S
  • MEMBER
  • 1997 NISSAN ALTIMA
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 190,000 MILES
My car cuts off then won't start. If we wait about an hour it will start again and then the same thing happens again. Codes read idle control module and knock sensor I believe. Will replacement of idle control module solve problem and if so, where is it located on the engine? Thank you
Sunday, March 1st, 2009 AT 8:47 PM

1 Reply

Tiny
JOEMBINGHAM
  • MEMBER
  • 1 POST
At 180000 I had to replace my knock sensor, 140.00 for the part, it is locted under the intake, u can see it from under the car, above the oil filter it is a 12mm, I used a gear wrench, made it alot easier
Was this
answer
helpful?
Yes
No
+3
Sunday, April 5th, 2009 AT 10:11 PM

Please login or register to post a reply.

Related Engine Stall While Driving Content

Code Read Retrieval/Clear
VIDEO
Code Read Retrieval/Clear
Instructional repair video
Engine Stalls While Driving
GUIDE
Engine Stalls While Driving
An engine that stalls while driving and then starts back up again, either immediately or after a short time is different from an engine that just wont start or if the...
VIEW MORE