2000 Mercedes Benz S430 brake pad reset code

Tiny
LEIFSRT
  • MEMBER
  • 2000 MERCEDES BENZ S430
2000 Mercedes Benz S430 Two Wheel Drive 50100 miles

replaced all pads warning still shows up that they need attention
Thursday, September 30th, 2010 AT 8:54 PM

1 Reply

Tiny
BLUELIGHTNIN6
  • MECHANIC
  • 16,542 POSTS
There is nothing to reset. If sensors and pads were replaced and light is still on then you have a short to ground somewhere.

If you didn't replace the wear sensors with the new brake pads, or if you used aftermarket brade pads without the place for the sensor to read than the light will remain on as well.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, September 30th, 2010 AT 9:11 PM

Please login or register to post a reply.

Related Brake Pad Rear Content

Brake Pad and Rotor Replacement - Rear
VIDEO
Brake Pad and Rotor Replacement - Rear
Instructional repair video
Pad and Rotor Replacement - Rear
GUIDE
Pad and Rotor Replacement - Rear
Step by step instructions on how to replace automotive rear brake pads and rotors. This article pertains to all rear disc brake vehicles. Begin with the vehicle on level...

Sponsored links