1995 Mazda B3000

Tiny
DAVID HAGOOD
  • 1995 MAZDA B3000

Drive Train Axles Bearings problem
1995 Mazda b3000 6 cyl Four Wheel Drive Manual

pulled motor out. Installed new clutch disk. Reinstalled engine. Everything lined up well. Put 2 bolts in bell housing. Got them snug. Heres the problem. Clutch pedal will not depress. It is pressured up high on the pedal. Does not feel like the clutch is working. Like hitting the brake pedal. What is wrong?

Do you
have the same problem?
Yes
No
Thursday, October 9th, 2008 AT 2:26 PM

2 Replies

Tiny
DOCFIXIT
  • EXPERT
  • 19,035 POSTS

Did you install new pressure plate and throwout bearing? Bearing maynot be placed correctly and will not slide on sleeve.

Was this
answer
helpful?
Yes
No
Please consider a donation if we helped you
Thursday, October 9th, 2008 AT 2:42 PM
Tiny
DAVID HAGOOD
  • MEMBER

I pulled motor back out and cannot find anything wrong. Are you supposed to bleed the slave cylinder upon reinstalling?

Was this
answer
helpful?
Yes
No
Thursday, October 9th, 2008 AT 4:54 PM

Please login or register to post a reply.

Related Transmission Clutch Pedal Replace/Remove Questions

Recommended articles