1997 Jeep Laredo no spark, no gauges

Tiny
POCKETRODS
  • MEMBER
  • 1997 JEEP LAREDO
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 165,000 MILES
While driving jeep died. Will turn over no spark. Have replaced crankshaft sensor, camshaft sensor. Gauges do not move, low gas light stays on when key on but have over half a tank. Engine light doesn't come on. Have checked all fuses and asd relay. Wiring all appear in good shape. Can hear fuel pump when key is on. Any ideas?
Do you
have the same problem?
Yes
No
Saturday, July 4th, 2009 AT 12:47 PM

1 Reply

Tiny
JDL
  • EXPERT
Hello, if there is no primary voltage to coil, or the injectors with the engine cranking, check for voltage input to the asd relay, if you haven't already. Voltage for the switch side of relay is battery voltage, hot all the time. The voltage for the coil side of relay is ignition feed, goes hot with the key on. You can unplug relay and use a testlite.
Was this
answer
helpful?
Yes
No
Saturday, July 4th, 2009 AT 1:34 PM

Please login or register to post a reply.

Recommended Guides