My fuel, water temp and oil pressure guage have stopped working. How do I repair them? Paul
Jan 1, 2008 at 12:28 AM
1980 Jeep J10 non functioning guages
1980 JEEP J10
PAUL SPEAGLE
- MEMBER
- 2 POSTS
- FOLLOW
Advertisement
You need to look for the voltage limiter or similar component that controls the input voltages to the gauges.
Jan 1, 2008 at 1:01 AM
Advertisement
In the wiring diagram, what will this be called? I have looked for something like this and can't find it. Would it be incorporated in the Ford type starter solenoid that Jeep used?
Jan 1, 2008 at 10:04 AM
Would it be incorporated in the Ford type starter solenoid that Jeep used?
I don't think its wired like that-if it is-you'll loose ignition switch power-Been looking for it in the Mitchell1 references for this year but nothing the only thing there could be a ground or the printed circuit board problem.
I don't think its wired like that-if it is-you'll loose ignition switch power-Been looking for it in the Mitchell1 references for this year but nothing the only thing there could be a ground or the printed circuit board problem.
Jan 1, 2008 at 1:59 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.