2000 Honda Prelude Motor rebuilt, Starts but wont Move

MISTERWEBB

MEMBER
2000 HONDA PRELUDE
4 CYL
FWD
MANUAL
108,000 MILES

Hello, I have a 2000 prelude(not SH) and I had to have the head resurfaced and rebuilt very recently. I got the car back after 1300 worth of work, drove home and now it will start right up but as soon as I put it in gear and hit the gas it dies. In neutral it will rev up if you barely push the gas and let it gradually gain RPM's. If I just gun it though it will die. Had alot of people look at it and we cannot figure it out. PLEASE HELP.

Thursday, July 30th, 2009 AT 12:15 AM

1 Reply

RASMATAZ

MECHANIC
75,992 POSTS

Dirty fuel injectors (cleaning the injectors often fixes this).
Bad MAP (manifold absolute pressure) sensor
Bad TPS (throttle position) sensor
Bad or dirty MAF (mass airflow) sensor
Low fuel pressure (leaky fuel pressure regulator or weak fuel pump)
Vacuum leaks (intake manifold, vacuum hoses, throttle body, EGR valve)
Bad gasoline (fuel contaminated with water or too much alcohol)

Sometimes, what feels like a hesitation is actually ignition misfire rather than lean misfire. The causes of ignition misfire may include:

Dirty or worn spark plugs
Bad plug wires
Weak ignition coil
Wet plug wires

Was this

answer

helpful?

Yes

No

Thursday, July 30th, 2009 AT 2:29 AM