Cross member

Tiny
RALLEYEGIRL
  • GMC

I was wondering if anybody had any suggestions about putting in a new clutch on my car that has a rusted frame and cross member

Do you
have the same problem?
Yes
No
Tuesday, March 28th, 2006 AT 4:57 PM

1 Reply

Tiny
BURRBRIAN
  • MEMBER

Howdy, I wonder if it is worth the time and trouble if the frame is too rusted but if you have your heart set on it find a big burly guy to break loose the bolts on the crossmember, even if he has to break the bolts you can always put new ones in. Then have him knock the member loose with a big hammer and go from there. Happy wrenching :D

SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, March 29th, 2006 AT 7:15 AM

Please login or register to post a reply.

Related Frame Rust Content

Doors

I Have Just Started Rebuilding My 88 S 10 Blazer And I Am Trying To Get The Doors Off Of It. However I Am Apparently Not Doing Something...
Asked by mat5387 ·
1 ANSWER
GMC OTHER

1975 Gmc Vin Plate

1975 Gmc 3 4 Ton 4x4 This Not A Question On Parts Or Repairs. I Purchased This Vehicle With A Clear Indiana Title. While Redoing The...
Asked by RadarMax ·
1 ANSWER
1975
GMC OTHER

Pontiac Grand Am 93 Se

I Have Purchased A Used Grand Am 93 Se. The Car Runs Pretty Good So Far. My Question Is This, I Noticed That There Was Water In The Trunk...
Asked by sdpeele ·
2 ANSWERS
1993
GMC OTHER

1966 Gmc 6 V. To 12 V. Conversion

Engine Mechanical Problem 1966 Other Gmc Models 6 Cyl Two Wheel Drive Manual Uk Miles I Want To Maybe Install A 1966 Chevy 300 Straight...
Asked by leeander1 ·
1 ANSWER
1966
GMC OTHER

Recommended guides