SPONSORED LINKS

1996 Ford Ranger No power

Tiny
LACEYB52
  • MEMBER
  • 1996 FORD RANGER
  • 4 CYL
  • 2WD
  • MANUAL
  • 160,000 MILES
My 96 Ranger just came out of the shop to get timing belt replaced. Now it has not power. It idles fine, but 1/4 pedal down gets no power. The mechanic double checked timing, mass air flow sensor, cadalidic converter, coil, compression, fuel pressure, and none of these were it. Neither of us know what to do. Can you please help.
SPONSORED LINKS
Monday, December 31st, 2007 AT 3:28 PM

1 Reply

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check the throttle position sensor it gives the computer the position of the throttle and indicates throttle pressure for the transmission to provide upshifts/downshifts/lock up thru the shift solenoids.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Monday, December 31st, 2007 AT 5:10 PM

Please login or register to post a reply.

Related Mass Air Flow Sensor Replace/Remove Content

Mass Air Flow Sensor Replacement
GUIDE
Mass Air Flow Sensor Replacement
After starting the engine post sensor replacement, the sensor instantly calibrates itself so there is no learn time required. This sensor is subject to debris and ...
VIEW MORE

Sponsored links