2004 Ford F-150 bank 1 PO171 AND BANK 2 PO174

Tiny
HERNAMV
  • MEMBER
  • 2004 FORD F-150
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 125,000 MILES
FAIL INSPECTION CODES
Do you
have the same problem?
Yes
No
Thursday, October 30th, 2008 AT 2:14 PM

1 Reply

Tiny
RASMATAZ
  • MEMBER
2004 Ford F150 bank 1 PO171 AND BANK 2 PO174

A lean fuel condition can be caused by:

* Low fuel pressure due to a weak pump or leaky fuel pressure regulator. (Use a fuel pressure gauge to check fuel pressure at idle)

* Dirty fuel injectors. (Try cleaning the injectors)

* Vacuum leaks at the intake manifold, vacuum hose connections or throttle body. (Use a vacuum gauge to check for low intake vacuum)

* Leaky EGR valve. (Check operation of EGR valve)

* Leaky PCV Valve or hose. (Check valve and hose connections)

* Dirty or defective Mass Airflow Sensor (MAF). (Try cleaning the MAF sensor wires or filament with aerosol electronics cleaner. Do NOT use anything else to clean the sensor, and do not touch the sensor wires)

* TIP: On many Fords, a P0171 and/or P0174 Lean Code may sometimes appear because of a bad Differential Pressure Sensor (DPFE). This sensor monitors EGR flow, and is located on the engine near the EGR valve. There are two hoses that connect the sensor to the tube that runs from the exhaust manifold to the EGR valve. The sensor misreads EGR flow and the computer increases EGR which has a leaning effect on the fuel mixture. The fix is to replace the DPFE sensor
Was this
answer
helpful?
Yes
No
Thursday, October 30th, 2008 AT 2:18 PM

Please login or register to post a reply.

Recommended Guides