1996 Ford Bronco O2 Sensor Sending Wire

Tiny
WILL@NFCFTACKLE.COM
  • MEMBER
  • 1996 FORD BRONCO
  • V8
  • 4WD
  • AUTOMATIC
  • 150,000 MILES
I am installing a air/fuel ratio gauge and need to determine the correct wire to connect to the gauge. As you know there are two sensors and each has four wires. I intend to connect the gauge at the nearest harness but am open to suggestions.
SPONSORED LINKS
Do you
have the same problem?
Yes
No
Sunday, December 6th, 2009 AT 11:18 AM

3 Replies

Tiny
BIGJIM79
  • MEMBER
I would suggest getting the kit that will have its own sensor and wont have the problems of cutting the wires.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, December 8th, 2009 AT 1:24 AM
Tiny
WILL@NFCFTACKLE.COM
  • MEMBER
Thanks for the input, but I already have everything installed and need to know what wire to connect the gauge. I was going to do it myself since the Trans Temp and Vac/Boost gauges were easy to connect. Interestingly, I already have O2 sensors on this vehicle, that are tied in to the onboard computer. Unless there is an adaptor to add a connection to the existing system; Cutting a wire is not a problem compared to mounting a whole other O2 sensor.
Was this
answer
helpful?
Yes
No
Tuesday, December 8th, 2009 AT 10:28 AM
Tiny
BIGJIM79
  • MEMBER
What systems are you running? Bully dog, banks?
Was this
answer
helpful?
Yes
No
Tuesday, December 8th, 2009 AT 8:55 PM

Please login or register to post a reply.

Related Oxygen Sensor Content

Oxygen Sensor
GUIDE
Oxygen Sensor
Oxygen sensors are made of reactive materials which limits their lifespan. Aside from mechanical failures such as shorted heating elements or physical damage, these sensors...
VIEW MORE

Sponsored links