2005 Chrysler Sebring replacing the EGR valve

Tiny
RANDYMELEA
  • MEMBER
  • 2005 CHRYSLER SEBRING
2005 Chrysler Sebring 6 cyl Wheel Drive Type unknown 99000 miles

My engine light recently came on and when I took it to get checked the code came up as po406 which is the egv valve. Can you please tell me how to get to this valve on my 2005 chrysler sebring convt.
Thanks
Do you
have the same problem?
Yes
No
Thursday, February 21st, 2008 AT 10:07 PM

3 Replies

Tiny
BLACKOP555
  • EXPERT
Either the DPFE sensor is bad and not reading the EGR valve its a common problem.

If it tests out good then the egr may be dirty and sticking open.

Your code stands for EGR excessive flow.
Was this
answer
helpful?
Yes
No
-1
Friday, February 22nd, 2008 AT 7:19 AM
Tiny
RANDYMELEA
  • MEMBER
Where is the dpfe sensor.
Was this
answer
helpful?
Yes
No
Friday, February 22nd, 2008 AT 9:22 PM
Tiny
BLACKOP555
  • EXPERT
I dont know on your specific vehicle it will be hooked to the egr through wire harness.

Best bet is to look up a pic. Online and find it.
Was this
answer
helpful?
Yes
No
-1
Friday, February 22nd, 2008 AT 9:25 PM

Please login or register to post a reply.

Recommended Guides