BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
Suburban: Jack Stand Placement
I have a 4WD 2002 Suburban, 3/4 ton, 8.1 ltr engine, and I want to start chaning my own oil, filters, etc.
I'm new to working on this vehicle, though (or any 4WD, for that matter). Where should the jackstands go on the front end?
have the same problem?
Friday, November 2nd, 2007 AT 2:48 PM
On the frame at the bottom of the fender.
Friday, November 2nd, 2007 AT 3:59 PM
to post a reply.
Related Tool Jack Content
Voltmeter Needle Unstable
I Have Suburban 2000, Model 1500. The Fuel Pump Failed At The Time When The Voltmeter Needle Was Very Unstable. After Fuel Pump...
Jack Up Your Car
When saving money by working on your car yourself you will need to do it safely by raising your vehicle off of the ground using a floor jack. Every person who has a vehicle ...
1995 Chevy Suburban K1500 125000 Miles. We Hav Eput Several New Fuses In To Cure The Problem, But They Just Keep Blowing Within A Matter...
Using Hose Disconnect Tool
I Have A 99 Suburban, 140,000 Miles, 5.7, That I Am Replacing The Fuel Pump On. No Problems Except That I Can't Get The Hoses...
1997 Chevy Suburban Car Shakes While Driving
Engine Performance Problem 1997 Chevy Suburban V8 Automatic 133500 Miles This Problem Has Been Going On For More Than A Week. Now The...
1999 Chevy Suburban My Car Shakes
I Just Wanted To Know Why My Car Shakes Every Time I Accelerate But This Does Not Happen All The Times Only When I Press The Gas And Every...
Ask a Car Question. It's Free!
Find a car manual for your car
Terms & Conditions
© 1999 - 2018 2CarPros, Inc.