1991 Chevy S-10 Brake + hazard lights not working

1991 CHEVROLET S-10
Avatar
RUDEMASTER
  • MEMBER
  • 2 POSTS
Brakes problem
1991 Chevy S-10 6 cyl Two Wheel Drive Manual

Brake and hazard Lights not working, bulbs and stop light switch are new. Suspect that it is the 'Little Black Box' Need Error codes to verify
Jul 4, 2010 at 2:24 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Check and test the directional/hazard switch
Jul 4, 2010 at 2:32 PM
Advertisement
Avatar
INTERNETMECHANIC
  • CAR REPAIR CONTRIBUTOR
  • 700 POSTS
Did you check applicable fuses, not only check fuse, check that the fuse circuit has voltage. Did you check for voltage to and from the stop lamp switch? Orange wire at the switch is hot all the time, white wire goes hot when the switch is activated. The brake lites are wired through the turn/hazzard switch.
Jul 4, 2010 at 2:43 PM
Avatar
RUDEMASTER
  • MEMBER
  • 2 POSTS
Found the problem. seems that the previous owner had spliced into the hot wire leading to the stop light switch. The splice was coming loose. We just redid the splice and all is working fine now. am so happy that it wasn't the 'Little Black Box'.
Jul 5, 2010 at 2:29 PM
Avatar
INTERNETMECHANIC
  • CAR REPAIR CONTRIBUTOR
  • 700 POSTS
Glad you got it going your way. Have a good day.
Jul 5, 2010 at 2:50 PM