Blinkers not working properly

Tiny
JUSTINLEE89
  • MEMBER
  • 2002 CHRYSLER CONCORDE
  • 3.5L
  • 6 CYL
  • 202,700 MILES
Okay, when I turn my blinkers on they will work for one or two seconds then stop. I've checked the bulbs and check fuses. I found a little black I think it is the flasher relay under my dash next to my firewall. Well I'll like get a screwdriver something out tap that and they'll start working again, but they'll stop right afterwards.
Saturday, June 1st, 2019 AT 1:15 AM

1 Reply

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 110,176 POSTS
Welcome to 2CarPros.

The turn signal flasher, also referred to as the combo-flasher, is mounted to an in-line bracket which is located to the right of the Junction Block (driver's side). The flasher can be removed by pulling in a rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification. If that is what you are hitting to make it work, replace the flasher.

Let me know if I can help in any way.

Take care,
Joe
Was this
answer
helpful?
Yes
No
Saturday, June 1st, 2019 AT 7:13 PM

Please login or register to post a reply.

Related Turn Signal Not Working Content

Turn Signal Problems
GUIDE
Turn Signal Problems
Turn signals are intended to help inform surrounding drivers of the vehicle's intended change in direction. Although there are a few different causes for signal failure...
VIEW MORE