CURIOUS TO KNOW HOW TO INSTALL AXELS AND TRANNY AND HOW TO CHANGE THE IMPUT SHAFT SEAL?
Jun 17, 2008 at 12:34 AM
1990 Acura Integra HOW TO INSTALL AXELS AND TRANSMISSION
1990 ACURA INTEGRA
MRAFD
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
Hi MRAFD,
To explain how would be a very long process and you might not understand too.
By input shaft, you mean the clutch shaft? Depends on makes, Honda manual all have to strip trans completely to do it.
Sorry to disappoint you but I hate to see any questions unanswered.
To explain how would be a very long process and you might not understand too.
By input shaft, you mean the clutch shaft? Depends on makes, Honda manual all have to strip trans completely to do it.
Sorry to disappoint you but I hate to see any questions unanswered.
Jun 20, 2008 at 8:09 AM
Advertisement