1990 Acura Integra cv axles

1990 ACURA INTEGRA
Avatar
67MATT84
  • MEMBER
  • 2 POSTS
Drive Train Axles Bearings problem
1990 Acura Integra 4 cyl Front Wheel Drive Automatic

I'm trying to change my cv axles in my 1990 acura integra and i have everything taking about like i'm supposed to but the axle will not pop out of the trans. i've tried every kind of pry bar that i can think of. Does anyone have any advice?
Nov 25, 2008 at 12:19 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS
Hi 67matt84,

Normally when it is hard to remove the CV jiunts from trans, I would use 2 pry bars, one on each side to even out the force.
Nov 25, 2008 at 2:43 PM
Advertisement
Avatar
67MATT84
  • MEMBER
  • 2 POSTS
well i will try that that thanks
Nov 26, 2008 at 5:12 PM