Manual Under-chassis Torque Specs needed?

Tiny
SHANE EAST
  • MEMBER
  • 2014 TOYOTA VIOS
  • 1.3L
  • 4 CYL
  • 2WD
  • MANUAL
  • 140,000 MILES
Hello, I’ll be replacing my clutch lining. Since replacing its components requires removing some parts and bolt and nuts before reaching into the transmission assembly (clutch lining replacement for the manual Toyota 2nz-fe), does anyone here can give the torque specs of all related components? (Axle nut, camber bolts, caliper bolts and pin, transmission mount bolts, gear oil drain plug, and inlet plug bolts, starter motor bolts). Thank you.
Images (Click to make bigger)
Thumb
Thumb
Saturday, April 19th, 2025 AT 5:26 PM

1 Reply

Tiny
KEN L
  • MASTER CERTIFIED MECHANIC
  • 54,138 POSTS
Sure, here are the torque specs to help complete your clutch replacement job.

Front Axle Nut (Drive Shaft Nut):
216 Nm (159 ft-lbs)
(Stake the nut after tightening.)

Strut to Knuckle Bolts (Camber Bolts):
177 Nm (131 ft-lbs)

Brake Caliper Mounting Bolts:
98 Nm (72 ft-lbs)

Brake Caliper Slide Pins (Guide Pins):
25 Nm (18 ft-lbs)

Transmission to Engine Mounting Bolts:
54 Nm (40 ft-lbs)
(Double check length-specific bolts as some may require slightly higher torque.)

Transmission Mount Bracket to Chassis:
64 Nm (47 ft-lbs)

Clutch Pressure Plate Bolts:
19 Nm (14 ft-lbs)
(Tighten in a star pattern in stages.)

Flywheel Bolts (Manual Transmission):
103 Nm (76 ft-lbs) + 90° turn

Gear Oil Drain Plug:
39 Nm (29 ft-lbs)

Starter Motor Bolts:
39 Nm (29 ft-lbs)

Let us know if you need anything else.
Was this
answer
helpful?
Yes
No
Sunday, April 20th, 2025 AT 12:08 PM

Please login or register to post a reply.