2011 Ford Mustang GT expansion valve

Tiny
MDMEYERS1982
  • MEMBER
  • 2011 FORD MUSTANG
  • 5.0L
  • V8
  • 2WD
  • MANUAL
  • 55,000 MILES
Just watched a video on youtube with you guys replacing a condenser on a 2011 mustang. I have a quick and easy question

Where is the location of the expansion valve? I have a compressor, dryer and expansion valve that I bought to replace, and I cannot find that single part.

location would be appreciated.

Thank you.
Monday, March 23rd, 2015 AT 12:07 PM

3 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Its' at the evaporator outlet line. It has to be removed so outlet line can come off. We don't have apic of it's location.
Was this
answer
helpful?
Yes
No
Monday, March 23rd, 2015 AT 12:22 PM
Tiny
MDMEYERS1982
  • MEMBER
  • 2 POSTS
Thank you,

Also how much PAG oil is needed for a new compressor, it has a sticker on it saying it needs to be filled
Was this
answer
helpful?
Yes
No
Monday, March 23rd, 2015 AT 12:30 PM
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
If you haven't already taken it off and drained it then drain it into a measuring cup and put in same amount that has been removed. You have to turn over compressor 6-8 times if you can when you drain it. Otherwise it wil be 3-4oz to add. If the compressor failed then yo have to flush the system form the evaporator inlet to the compressor to get the junk out or the compressor will fail again. Also replace the receiver/drier. Use a/c flushing solvent yn-23 or equivalent. Add oil through low side port then vacuum evacuate at 28" if possible for 15 minutes, do a Freon sweep then evacuate for another 15 minutes. Make sure you adjust clutch to proper air gap.014-.024" also replace orfice for evaporator if you have one.
Was this
answer
helpful?
Yes
No
+1
Monday, March 23rd, 2015 AT 1:38 PM

Please login or register to post a reply.

Related Air Conditioner Expansion Valve Location Content

VIEW MORE