2010 Ford Edge ABS light lit

Tiny
JIMBAKERJR
  • MEMBER
  • 2010 FORD EDGE
  • 60,000 MILES
Changed rear wheel bearing hub. Given the wrong abs cable. Had to buy the right one for drivers side. Installed right cable and light still on? Disconnected battery over night, this did not clear the the light. Question is, is there a fuse for the system that might be blown?
Do you
have the same problem?
Yes
No
Saturday, October 19th, 2013 AT 8:20 AM

4 Replies

Tiny
HMAC300
  • EXPERT
You need a scanner to erase abs codes so light will go off
Was this
answer
helpful?
Yes
No
Saturday, October 19th, 2013 AT 8:52 AM
Tiny
JIMBAKERJR
  • MEMBER
Thank You for your reply. Went to Auto Zone and they said that they could not clear a ABS code. Do you have to go too a dealer to have this done?
Was this
answer
helpful?
Yes
No
Saturday, October 19th, 2013 AT 11:17 AM
Tiny
HMAC300
  • EXPERT
No you don't have to go to a dealer, any service station that repairs brakes can do it, not sure if there will be a charge or not but they can clear it but if it comes back on then there is something else wrong with it. Just explain to them what you did. Most are happy to help.
Was this
answer
helpful?
Yes
No
Saturday, October 19th, 2013 AT 11:22 AM
Tiny
JIMBAKERJR
  • MEMBER
Thank You for that info, will try that on Monday. Thanks
Was this
answer
helpful?
Yes
No
Saturday, October 19th, 2013 AT 11:57 AM

Please login or register to post a reply.

Sponsored links