Toyota Rav4 Rear Turn Signal

2007 TOYOTA RAV4
40,000 MILES
Avatar
RUTGERSGUY92
  • MEMBER
  • 1 POST
how do you replace the bulb for the rear turn signal in a 2007 Toyota Rav 4?
Dec 18, 2010 at 12:13 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
KHLOW2008
  • CAR REPAIR CONTRIBUTOR
  • 41,814 POSTS

REAR COMBINATION LIGHT ASSEMBLY COMPONENTS

REMOVAL
HINT:
• Use the same procedures for the RH and LH sides.

• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.

2. REMOVE REAR COMBINATION LIGHT ASSEMBLY

a. Remove the 3 nuts and disconnect the connector.

b. Detach the clip and remove the light.


DISASSEMBLY

1. REMOVE REAR COMBINATION LIGHT BULB

a. Turn the 3 bulbs in the direction indicated by the arrows and pull to remove them.

REASSEMBLY

1. INSTALL REAR COMBINATION LIGHT BULB

a. Turn the 3 bulbs in the direction indicated by the arrows to install them.

INSTALLATION

1. INSTALL REAR COMBINATION LIGHT ASSEMBLY

a. Attach the clip to install the light.

b. Install the 3 nuts and connect the connector.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

© 2008 Mitchell Repair Information Co., LLC.
Images (Click to enlarge)
Attached Media
Attached Media
Attached Media
Attached Media
Attached Media
Dec 20, 2010 at 5:45 PM
Advertisement